Questions & Answers for: Harley Davidson XL 1200 R Sporster Roadster battery cable

...battery has correct voltage when metered, then check for loose terminal connections (+ & -), if their tight then check starter relay for loose connection, if no loose wires on relay but it does click ...

battery/starter cable can't access bolt do I have replacing battery/starter cable & can't access starter bolt. do I have to remove starter to replace cable? 1999 hd1200 On some models it is possible ...

battery cable, then the positive. Remove the nuts holding the wires to the starter, clean all connections at the starter, frame and battery with a wire brush. Get them CLEAN!! Make sure the big cables

battery cable connections first. See if the battery is at a fully charged state. You may have to remove it, and take it to the nearest auto parts store for a load test. Before you do check the battery

...off the motor shutt down, no electric power to any thing. You have a dead short try a different battery if ya get the same thing your wireing is burnt or shorted out sum ware

...cable which needs to be checked at "BOTH" ends. 3. Battery voltage, 12.5 volts or better,to the main circuit breaker to the ignition switch to the security/ignition fuse to the TSM/TSSM module to the ...

...battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter. 4. Bank angle sensor ...