...cable from the battery with a wrench. 3. Disconnect the positive (+) cable. 4. Remove the hold-down clamp which holds the battery in place. 5. Lift out the battery. 6. Inspect the battery tray for ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...battery cable but is can destroy the insulation on the windings of your starter if it hasn't already done so. A battery in a motorcycle usually only last for about two years. You can extend the life ...
Question about 2003 FLHTCUI Electra Glide Ultra Classic
battery cable connects. Disconnect this wire and reconnect any wires that were on the connector with it. What you're doing is isolating the voltage regulator. Now, touch the negative battery post with
how to remove batter from FLHTCU If you mean the battery, remove the seat. Move the ECM out of the way. It is on top of the battery. Remove the battery hold down. Remove the battery cables. Lift the ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...battery cables especially ground cable to frame. 3. Loose connection at ignition coil or plug between ignition sensor and module. 4. Spark plug cables in bad condition, shorting / leaking, spark plug ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
battery hold down if installed, undo the negative cable, undo the positive cable, pull up on the battery removal strap if present and not buried under the battery etc OR otherwise lift the battery out
Question about 2000 FLHTCUI Electra Glide Ultra Classic
battery cable before proceeding. Inadequate safety precautions could result in death or serious injury. 2. Unthread bolt and remove battery negative cable (black) from battery negative (-) terminal. 3
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 4. Bank ...
Question about 2001 FLHTCUI Electra Glide Ultra Classic
...battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 8. Loose ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary. 4. Loose ...
Usually answered in minutes!
681 Questions
291 Questions
199 Questions
191 Questions
187 Questions