Base Unit unable to use All of the lights are lit on the base unit display.you cannot use any of the phones . Your base has taken a strike to the processor and it is stuck trying to boot up. If you ...
base unit Base unit suddenly dead. New batteries in base unit handset to no avail. Outlying handsets indicate "No link to base. Move closer to base. Try again." Check the power supply to the base unit
Question about KX-TG5422M Cordless Phone
...phone, but lost the one handset. I bought another handset on ebay, and it will not "see" my base station. Is there some way to fix tjis? Hoping you can help Tim I ordered a new kx-tg560m ...
kx-tg1100 I register my kx-tg1100 to work like handset with another base. Now I cant preregister to his own base. I try to reset base but when a pres "SETTING BS" noting happend (?INPUT CODE? doesnt ...
Question about KX-TG2356 Cordless Phone
Phone says I am too far away from the base--panasonic kx-tg2356s My phone says I am too far away from the base, I can even walk into the same room as the base and be right next to the base and it ...
TOO FAR FROM BASE REGARDLESS OF HOW CHARGED THE HANDSET IS....IT WILL GIVE A MESSAGE THAT IT IS TOO FROM THE BASE AND WILL NOT CONNECT. Hi! This may cure your problem! Re-registering the handset If ...
can not rec a dial tone, phone states no link to base move closer If “No link to base. Move closer to base, try again.” is displayed even when using the handset near the base unit, the handset may ...
Question about KX TG4031 Cordless Phone
Unable to change handset registrations from old base to new. Although I could hear a faint dial tone when I pressed "talk" on all four of my handsets, I couldn't talk or hear over them. Figuring ...
Question about KX TGA810 1Line Cordless Expansion Handset
...phones cordless kx-tga810 335 is the magic code when you want to remove a previous handset or base station registration! Handset: 1 " (middle soft key) i L i # 2 Enter "335". 3 "Cancel Handset" ...
Question about KX-TG1033S Cordless Phone
how do i fix phone base, keeps flashing and states, no link to base, to move closer to base. is close to base and all connections seem to be fine Is base plugged in? If no, plug it in, you have to ...
Usually answered in minutes!
1,197 Questions
619 Questions
465 Questions
463 Questions
293 Questions