Questions & Answers for: Dodge Intrepid bank1 sensor 1 location

...1 code a Po152. Can you please tell me what this means? P0152 is o2 sensor 2/1 voltage high. Sensor 2/1 is your right bank upstream o2 sensor located in the manifold. Make sure it is pluged

cyclinder locations for 3.3 dodge intrepid, need location, so I can locate which side is bank 2 O2 sensor. drivers side is 1, 3, and 5. Bank 2 is pass side.

Can't find oxygen sensor bank 2 sensor 1 location in my 96 dodge intrepid. The O2 sensor on the 3.5L is located towards the rear of the engined mounted in the exhaust manifold.

...Sensor is directly in front of the upper engine block on the driver's side, next to the timing belt cover. It looks like a little flat electrical plug, about 1"square. with 3 wires. It is held in ...

...can't find any diagram that has a bank 2 sensor 2 only bank 2 sensor 1 just change the o2 sensor tha code its saying is irrelvant to that model cause it has a generic ECM that fits several other ...

1: Find the sensor (hardest part) Step 2: Remove the (1) bolt holding it into the engine block Step 3: Remove the wiring harness from the old sensor Step 4: Plug the wiring harness into the new sensor

...located the 02 sensors. 4 of them. heater? P0141 is O2 Heater Circuit (Bank 1, Sensor 2) It will be the sensor AFTER the cat on the side that has #1 cylinder. On your car it's the PASSENGER

Sensor 1 is always before the cat and sensor 2 is always after the cat. So bank 2 Sensor 1 would be the O2 on the passenger side of the motor before the catalytic converter. You should see it threaded

...Code PO154 Bank 2 sensor 1 which is the driver side sensor staying in the middle range, it might need replacing. Normally the O2 would go active or lazy but staying in the middle is new for

where is theoxygen high voltage sensor circuit bank1 sensor 1 located on the converter. 02 sensor. some have 4 of them. could be in front or behind.