Question about 1999 Legacy
...sensor,should produce a steady reading of .01 to .02 volts. after warming up about 2 minutes, it should fluctuate between .1 and .9 volts, meaning it has reached closed loop status. I hope this helps ...
...1 As far as there being no knock sensor on a 99 2.2 I beg to differ. I have a 99 legacy and just had a diagnostic done and mine is bad. If there is no knock sensor why would it say it was bad and why ...
...1 hour labour. Where is it located and where can I find a how to? Any advise appreciated. Jason the sensor is located by the crankshaft pully and should have a 2 wire plug on it. as far 260 for the ...
1/2 turn, then it just stops turning. You have compressed the sealing washer correctly. Remove your wrench, plug the new sensor back in, and lower the car. Do not be surprised if the computer is a bit
Where are the O2 sensors located? I hace a P0131 Where are the O2 sensors located? I have a P0131 code and want to trace the wiring and connectors before replacing the O2 sensor. the o2 sensors are ...
...1 sensor 2 low, the 2 meaning that it is downstream past the catalytic converter but not on the manifold. - Heated Oxygen Sensor (H2OS) Bank 1 Sensor 2 circuit open shorted to ground - Heated Oxygen ...
bank1 sensor 2? For 1999 Subaru Truck Forester AWD 2.5L MFI 4cyl the Oxygen Sensor is located under hood, center, rear engine area, mounted on catalytic converter. Fig. Oxygen sensor location-Forester
...Sensor 1 (output shaft rotation sensor) is mounted to the extension case (from the outside of the case). The sensor outputs a pulse signal which is transmitted to the TCM where it is converted to ...
Question about 2005 Legacy
...legacy located location for the vehicle speed sensor on 2004 subaru legacy Usually in the transmission where the speedometer cable used to be. Ok so I'm assuming if my speedometer works it's vss ...
...sensor-2 bank1 heater control-circuit malfunction ===causes --wiring--Heated oxy sensor---ECM I would replace the sensor first and see it that fixes the fault. remember to use a code reader to reset ...
Usually answered in minutes!
447 Questions
411 Questions
381 Questions
354 Questions
317 Questions