Questions & Answers for: band clamp

Question about ZJ1217 Front Load Washer

1 Answer

clamp band securing the seal to the door rim on the washing machine and examine it carefully for holes or tears. Many can be prised off with a flat-bladed screwdriver they have a spring system holding

Ad

band clamp from between the converter and the exhaust manifold, then loosen the rest of the system and to get enough clearance to slide the converter towards the front of the vehicle but you will need

Ad

...band clamp(s) is necessary to loosen on hose to disconnect from air filter box top. 2002 Buick Rendezvous. Step 1 Unfasten wire harness to MAF (massive air flow) sensor located on top of the black ...

Question about 1 HP Sta-Rite Pump: 1.5" in/out, Center Discharge, 240V, w/Hair & Lint Pot

1 Answer

plastic knob instead of the nut. When putting the assembly back together, be sure the clamp/band is seated correctly around the two pieces. Epecially on the bottom portion of the pump. Hope this helps

Question about ATV Spot Sprayer 26 Gallon, 2.2 GPM, 12 Volt

1 Answer

...band clamp, take off the hose, and cut off the last 1" of the rubber hose so you get a fresh end. Push the freshly cut end onto the wand, and tighten the band clamp. Did that fix it? If not, you'll ...

Question about L66600 Front Load Washer

1 Answer

clamp band securing the seal to the door rim on the washing machine and examine it carefully for holes or tears. Many can be prised off with a flat-bladed screwdriver they have a spring system holding

clamp band securing the seal to the shell of the machine and examine it carefully. Many can be carefully pried off with a flat-bladed screwdriver, but some have a tensioning arrangement that has to be

Question about L66600 Front Load Washer

1 Answer

spring style hose clamps, I would try a good quality adjustable band clamp (stainless steel). Make sure the hose is seated all the way down and that the band is below the retainer bulge in the fitting

...band clamp holding it in place? Cut the band. New part should come with new clamp band which (wait for it...) requires a special tool to install, but can often be fitted by careful use of dull side ...

...end and i remove it do it have a clamp on the other end of the tie rod end? Yes, you will need a clamp tool to replace the boots after you get the tie rod changed. Just cut off the old band

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Brad Brown

Level 3 Expert

19187 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...