Broil works but Bake does not My Hotpoint RGB745 broils fine and the burners work, but the bake just stopped working. With the broil on, the glow plug current is approximately 3.3 amps, with bake on, ...
Question about AOCS3040 Electric Single Oven
...one is out, you won't get squat for heating - the problem is most likely with the DLB relay or the bake relay on the relay board. (The element should ohm out between 20 and 40 ohms if it's
Question about AOCS3040 Electric Single Oven
...bake element at the contacts after the relay clicks on. The wires go up to the computer part of the stove. What else could the problem be? Thanks in advance. The electronic range control or ERC will ...
Question about AOCS3040 Electric Single Oven
...Bake relay. if either one is bad, or not energizing, you won't get any power to the bake element. (The bake element runs 100% of the time during the bake cycle. broiler only operates 25% of the time ...
...bake /broil relay. This is what the new replacement relay looks like Wiring this new relay in to replace the old one is not overly difficult. 1 - Disconnect power 2 - Remove the cover panel 3 - ...
Question about LRE30453ST (Electric) Stainless Steel Range
...relay board for the bake and broil elements. Check for incoming voltage between the red and black wires. You should have 230 volts all the time.Set the oven control to bake at 350 degrees and check ...
Question about LRE30453ST (Electric) Stainless Steel Range
the control board if you can't hear the relays on the board clicking when you power up the elements bake or broil then its either the low voltage side of the board,if you hear clicking then the relays
Question about LRE30453ST (Electric) Stainless Steel Range
...elements can be tested with an ohm meter for continuity. There is a relay in control / clock for both bake and broil elements. If elements test good, then those relays need to be tested for
Question about LRE30453ST (Electric) Stainless Steel Range
...Bake mode. Must be the relay board. I want to know what relay is involved in powering up the bake element. What are the terminals to test Like DLB, BA and L2? ...
Question about LRE30453ST (Electric) Stainless Steel Range
...relay board that control the bake element. If the continuity is present when the oven is turned off, or if the board is visibly damaged or burnt, then it's likely that the relay board needs to be ...
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions