Questions & Answers for: bad conductors Computers & Internet

...conductors tward the back of the board. most likly one of them are bad but sometimes the soldering can be faulty. look for signs of cold solder if so just resolder and should be good if not also look ...

brake lights keep going out ..and i change the fuse already??/ three possible origens: bad pedalswitch bad intermitent emergency light flasher bad connection of the rear connector of the light located

Reset Photo Conductor Kit I have a bad photo conductor in my printer and replaced it with another one. However, when I try to reset, I get the message that the photoconductor is bad. What am I doing ...

I have a bad photo conductor in my printer and I have a lexmark e450dn printer it's showing error 84 replace photo conductor than i chanege new photo counductor but still it's showing same error i ...

BAD CONTACT? ANY IDEAS? DON'T KNOW HOW TO REMOVE TONEARM. BEST, LOU No continuity means you have an OPEN, not a short. Before you tear the tonearm apart, check each of the 4 contacts for continuity to

...better. If your switch has a wire, the wire is soldered to the bulb holder, but the switch may be bad There is a second wire or metal conductor running to the back of the flashlight. This conductor ...

...dimmed, (2)-(A) doesn't flicker, (3)- using incandescent lamps-Probable faulty splice at switch or bad switch "B". If "B" is full on probably a bad switch, but could be connection. If (2)-"A" does ...

...bottom line: Shorten the length of the conductors or increase the conductor size to avoid voltage drop. Tank check valve bad. Allows air to flow back into head. Causing the comp. To start under

f-250 got the diagnostc code PO308 p d Misfire on cylinder 8.  could be numerous things.  bad plug, bad coil pack bad plug wire. from not being seated completely to corroded terminal ends to

...causes may include loose connection, voltage drop (undersized circuit conductors), wrong type of fuse, bad compressor, motor or capacitor, possible bad fan motor or compressor or start up ...