Questions & Answers for: Hyundai Elantra bad conductors

2001 hyundai elentra scanner said i have a bad cam sensor and map sensoer replaced both and the scanner is still reading the same code 2001 hyundai elantra 4dr coupe. Scanner said map sensor and cam ...

Ad

Question about Motor 2002 Elantra

1 Answer

i have a 2002 hyundai elantra 4 cyc automatic shifting from low to drive jerks bad and idies bad Step 1: Check/test your TPS (throttle position sensor).. it may have bad spots in the potentiometer.

Ad

...You need a muffler shop or remove it yourself if its bolted on. Cracked manifold, loose pipe or bad gasket. If it smells bad you might have a bad oxygen sensor. Is the check engine light

...Well the P0107 is a MAP sensor code( Manifold Absolute Pressure Sensor) this is usually caused by a bad sensor or a bad connection, a vacuum leak could also cause this code to appear. The P0175 is a ...

Question about 2007 Elantra Limited Sedan

2 Answers

...on the starter relay. It should have battery voltage. If not, the battery, terminals or wire is bad. Step 2 Check the small wire on the solenoid for power when the key is in the start position. ...

dears... i have a problem with centre lock of the right door, sometimes it locks with all doors, and sometimes it doesnt lock, i saw it very clean , so i think its electrical problem.. what can i ...

...(June ,148k miles and Dec, 156k). It does great in cold weather but above 50 degrees it slips bad! Any ideas? if a clutch is bad it dont choose to be good in hot or cold, maybe it is the trans ...

...first. Make sure they have not blown. Sometimes these problems are hard to find. You could have bad wires, loose connections, or something shorted them out. You really need to access a voltage ...

Question about Motor 2003 Elantra

1 Answer

...on my 2003 hyundai elantra what could cuz this voltage drop? This could be attributed to wiring issues. Check your wiring for bad ones, exposed conductors or loose ones. It could also be the

Car blows water out of water compartment causing it to overheat Replace the pressure cap might be bad. If the cap is does not solve the problem have it checked for a bad thermostat or possible bad ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...