Questions & Answers for: Ford Ranger bad conductors

Is it a bad Slave Cylinder or a Master Cylinder on my 00 ranger? i need to know how to tell if the master cylinder or the slave is bad on my 2000 ranger i have to pump the clutch peddle for a few ...

the # 2 coil packs keep going bad This is a stretch - but strong possibility. Please don't zing me too hard for trying... I believe that the 12v wire or its connectors are impeding the flow of current

what causes a ford ranger to run rich Low coolant ,bad temp sensor ,plugged air filter ,faulty egr valve ,fouled plugs ,throttle position sensor ,plugged fuel filter ,bad thermostat Bad o2 sensor cat ...

When I am going down the road my truck shakes really bad. But only when I am on the gas. What could be wrong with it? it could be a "U-joint" in the driveshaft, a bad tire on the drive axle,a harmonic

when my 1994 splash ranger gets to about 50-55 it starts to shake really bad? Couple things it could be: Busted belt in the front tire (left or right) Bad ball joint Bad shock Bad tie rod

I have a fuel pump fuse that keeps blowing. If I jump start it the fuse did not blow. now it blows even if I jump start it. any ideas what is causing this. I am off to check all my wiring........ ...

miss fire on number 3 cly po303 code on 2000 fodr ranger 4.0 Causes for a cylinder misfire include. Bad spark plug, bad spark plug wire, bad coil ( or coil pack) if no wires, Bad fuel injector..I ...

...First there are a couple of things that could make this happen,1) corrosion on battery terminals2) bad chassis ground from battery3) weak cells in battery (bad battery)4) bad starter.1) If it is ...

1989 ranger..engine turns slow when trying to start need a new battery Possibilities are 1) Bad battery, 2) Bad battery cables, 3) Bad starter, 4) Damaged engine. If it will turn over properly with a ...

...the fuel pump will kik on sometimes it will not anybody no why it will not stay workin continously Bad ground, bad fuel control module, or faulty plugs. Motor on pump is going