Questions & Answers for: MagLite bad conductors

...need to disassemble the flashlight I can't figure out how to do it. I found out the light bulb was bad even though it looked good. Had a fine break in the filament that I couldn't see with my eyes. ...

...powder residue to form, you will have to spray a solvent into the torch to free the batteries... bad news? the corrosion cannot be fully cleared and the maglite will always be on the blink...

Repaced bulb and battery light will not come. Switch replaced in 2004 The switch probably went bad again, contact Maglite at www.maglite.com and they will replace it at no charge.

it or play with the switch to get it to come on again but it doesn't stay on for long The switch is bad, contact Maglite at www.maglite.com and they will repair it under Warranty

...Another possibility, which is more likely the problem, is that a battery or battery unit has gone bad and needs replacing. Good

...I keep my maglite flashlight connected to the charger continuously while not in use? It would be a bad idea. The battery would soon not be able to hold a charge. It's best to charge it up fully and ...

...better. If your switch has a wire, the wire is soldered to the bulb holder, but the switch may be bad There is a second wire or metal conductor running to the back of the flashlight. This conductor ...

....if you remove the bulb and check the voltage using a multimeter ,if its under 3 volts you have a bad connection somewhere in the

...have corroded and jammed inside.Got 1 out, 5 stuck fast. How do I get the damn things out! The bad news is, the torch will likely not work even if you could remove them which is unlikely. The ...

Can't open end to cha be how do you change the batteries on a Mini Maglite cannot open the back housing on it on mii mag lite they corrode when the batteries go bad and some will never open .