Questions & Answers for: bad brakes

Question about 1995 Suburban

2 Answers

on 95 Suburban Checked fuses, bulbs, and brake switch. All are working fine, still no brake lights. Bad or borken wire harness in the steering coloum. check power to brake switch, should have power on

Ad

...and that should correct the problem More than one problem. Brake lights will be blown fuse, bad or miss adjusted brake pedal switch, all brake light bulbs bad, broken wiring in same. no panel ...

Ad

Question about 2000 Neon

3 Answers

My brake fluid is leaking. What could be the possible problem? bad master cylinder, broken or damaged brake line, bad wheel cylinder, bad seal on brake fluid reservoir cap. You need to look at the ...

...brake is locking the wheel off while driving and the brake is applied most common cause would be a bad disk brake caliper, or bad brake hose. the way to find out witch one, is to jack up the front

Question about 1992 Accord

1 Answer

...switch staying on? try pulling up on the emergency brake pedal to insure the "e" brake switch is'nt bad before you replace a suspected bad brake light switch on the steering column. if you suspect a ...

Question about 1992 Accord

2 Answers

by a bad pressure differential valve or bad flexible brake line. You didn't say if it was one or both brakes affected. If it is only 1 side, chances are you have a bad flexible hose to the caliper

Question about 1999 Grand Cherokee

1 Answer

no brake lights Check for a bad fuse in the fuse panel under the dash and the brake light bulbs in the brake light housings for bad bulbs. Next check the brake light switch at the brake pedal to see ...

...bad brakes. (do explain tighter?) (to a blind, no leg man) first fix bad brakes, then worry ABS. last explain tighter. in driving school , they teach , how to drive (safely) with a stalled engine as ...

Question about 2002 TrailBlazer

1 Answer

brakes are locking up Bad caliper or trash in the line. I would think that it would be the caliper or a bad brake cylinder. This is the hydraulic cylinder on a disc brake that wont release or it would

brakes are bad. (WHY IS VAST) 1: ALL FUSES GOOD. 2: OBD2 SCAN THE CAR, AND FOR SURE ABS SCANS TOO. 3:IF ABS SCANS SAY A SENSOR IS DEAD, I MAY BE OR THE WHEEL LOCKS UP. 4: BRAKES ARE BAD, SORRY ABS CAN

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...