Questions & Answers for: back up sensor

...sensor first, truck would still die after about 10 minutes of idleing, it back-fired thru the engine and blew off the back of the intake manifold. Pulled the monifold, reglued end-cap and put back in ...

Ad

...sensor back in and back probe the light and dark blue wire on the side of the plug. when you are turning the motor over it should go back and forth from .3 volt to 5 volt if it dont fluxuate you need ...

Ad

Question about 1998 Avalon

2 Answers

sensor one are AF sensors. Both front and back O2 sensors work the same way and test for the same thing. However, the openings on the tip are usually slightly different. The rear sensor has more holes

Question about 1988 D-Series Pickups

1 Answer

...sensor is completely flush to back of timing gear housing (cover). If sensor is not flush, damage to sensor mounting tang may result. 4. Install mounting bolt and tighten. Refer to Torque ...

Question about 1988 D-Series Pickups

1 Answer

...and put the screw(s) back in. Sometimes the sensor goes in thru the back of the range and you must remove the back panel on the outside (usually a silver panel, be careful, they have sharp

...sensor doesn't beep when backing up, the radio still will lower as backing. took back to body shop, they could not find a problem. said they talked to ford service and stated that reverse sensory is ...

...back on the sensor The camshaft sensor is not in the back on the 98 4 cyl its right in front. All you need to do is take off the 3 bolts on the top of the heat shield and pull it back a bit and it ...

Question about 2001 ML 320

1 Answer

...Volts(Bank 1 Sensor 2) What does this mean ? air fuel ratio sensor ,the back one is not reading correctly.have a scan check & read the sensor.most likely is the sensor .bank one ,the back ...

...sensor on the back of the motor called crank sensor maybe the crank sensor its on the back of motor on the passenger side I is most lickly a cam sensor or a oil presur sensor need a picture to be ...

...sensor code came back on Possibly the replacement crankshaft position sensor is defective. The other side of the sensor, on the crank shaft, some times the crank shaft needs to be cleaned. After you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...