...doors. Open driver's door. Carry out the following within 24 seconds: Turn ignition switch ON and back to LOCK position 3 times. Remove key. Press and release driver's door courtesy light switch 3 ...
back door. Handle "loose". Lock works fine, but door won39;t open. The relay rod inside the door has broken (not likely), one of the retaining clips that hold it in place are broken
mazda 3 wont start after crash car won39;t crank after crash Check to make sure the transmission is not on drive. If so put it back on park then try to start it.
...won't rool up If it is electric then you may have to replace the window motor, if it is a hand crank window then just take off the door panel and put the belt that goes from the crank to the ...
...back and forth ok, but won't stay shut Check to see if anything is restricting it from closing inside of the crevice where the wheel travels and locks. Sometimes debris from trees, dirt or ...
won39;t open the open lever might be broken. This part can be replaced separately. Door Spring If the microwave door won39;t open the door spring may have broken. The door spring is located inside
...open up door to acess power window switch 2007 mazda 3 can't seem to find "screw" to take interior panel off, just want to reseat master window switch, wife can't use it, I ...
...is stuck. Won39;t open. Right sliding door was getting really hard to close and open. Now it won39;t open at all. What could be the problem? it is NOT the child lock switch! it might be the
...won39;t open This is what fixed the my car's driver's door that was stuck closed and locked: the plastic piece that function as the manual lock/unlock on the inside of the door (it's black but when ...
...won39;t shift into reverse I can39;t get my 2011 Mazda 3 to go into reverse! Apparently some of these won't go into reverse unless the park brake is on. It has almost killed us twice so ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions