Questions & Answers for: axle caps removing

...wrench in a vise. 4. Compress the vise to force the bearing caps into the yoke. Force the caps enough to install the retaining clips. 5. Install the bearing cap retaining clips. 6. Install axle

axle out about 10"so they are out of the diff.Now remove the cap bolts(4-5/8"bolts) and remove the caps(mark the caps so they go in excactly the way they came out.be careful the diff might fall out.If

...removing the wheel, (2) remove the silver colored cap in the center of the hub, (3) remove the cotter pin that goes through the axle nut and axle, (4) remove the axle nut, (5) remove the disc brake ...

...caps and pin from the center of my axle but my axle still will not come out Bearing caps? Put them back in. and retorque, I hope you didnt ruin anything. After you take the bolt and and the large pin ...

...brake calipher assembly by taking out larger bolts from back of calipher. Remove brake rotor. Pull axle toward middle of vehicle, you may have to tap axle end with small hammer being careful not to ...

...tike? I was assembling the trike for my daughter and by mistake i have fixed the cap nut on the axle without placing the rear wheel. I was assembling the trike for my daughter and by mistake i ...

...ground a few inches, remove brake caliper and hang with bungee cord or ??? to side and then loosen axle cap nuts and then loosen axle retainer nut and remove it and washer and then pull axle out and ...

TIRE REMOVAL 2000 HD ROAD KING raise wheel of the ground. remove and support brake calipers, loosen axle cap nuts, remove axle nut, remove axle keeping note of where spacers come from etc. so you will

...axle caps and then put them back on or can I buy new axle caps and were can I get them I don't exactly see how axle caps fit into you putting the wheels on wrong. Also, what you did is only a problem ...

...caps first and then tighten axle nut you need to loosen slider cap nuts and then retighten them to 11 ft lbs. reinstall brake caliper and torque bolts to 30 ft lbs. Spin front wheel to make sure its ...