Questions & Answers for: avr 10

...AVR 146 shuts off after 10 seconds by itself I purchased this refurbished receiver in June '08. I was watching it yesterday for about 2 hours, turned it off and went to the gym, and when I came back, ...

...center channel on my AVR 7000 is a lot lower than the fromt two channels. Is this normal. I had to adjust the setting up 10 db to equal the db of the left and right fromnt channels. I have same ...

...10 years but recently broke. Apparently it the AVR circuit board. A common problem with older generators. The bad news is it's expensive. After much searching I found it Mitsubishi part # ...

...AVR 3200 for about 10 years - occasionally (maybe once every 6 months), the error overload button comes on... for no real reason than i can detect (ghosts in the machine, maybe)... rebooting has ...

...retrevo.com http://www.retrevo.com/support/Denon-AVR-1707-Receivers-manual/id/696ci073/t/2/ How did test tones sound? Page 10 Muting should be OFF. EXT IN should be OFF. VCR and CDR/Tape NOT

my denon avr 3802 reads no back speakers and there is no power to them. any ideas You must TELL it it has back speakers and assign the amplifiers for them. It's in the manual. Page 10-12.

...to turn ON my Harman Kardon AVR 300 rds power lisht is in red colour Hi, Check the speaker wires that they are not shorting. Check the fuses on the back and then unplug it for 10 minutes. Good

...AVR-75 seems to stay in standby (red standby light is on) and I don'd get surround sound through it. How do I get it out of standby? if the receiver does not power on from standby there is a ...

Need power fuse type for a Harmon/Kardon AVR 10  • it may not just be the fuse 4A 125Vthat you want..but let me know if you need further assistance!

...AVR 146 wont stay on when hit power when I hit the power button to turn unit on it will stay on for roughly 10 seconds and then turns right back off. Probably was damage buy a power surge, Internal ...