Questions & Answers for: automatic garage door open itself

...garage door it goes to the bottom of the door and then opens itself back up automatically. Any suggestions? Thank you. The door obstacle detector(reversing switch) needs adjustment, or the down limit ...

...garage door opener to start and stop with the remote... When I go to stop my Sears opener with the remote before it's through opening or closing, it automatically starts going in the other direction ...

GARAGE DOOR OPENS BUT WILL NOT CLOSE AUTOMATICALLY GARAGE DOOR OPENS AUTOMATICALLY BUT TO CLOSE, WALL UNIT BUTTON MUST BE HELD DOWN UNTIL DOOR TOUCHES FLOOR, OTHERWISE DOOR WILL MOVE DOWN ABOUT 6 TO ...

Garage door opening by itself This is a continuation of the previously stated problem. We have disconnected the keypad (which was wireless) as well as the wall button, which was wired and it is still ...

Garage door keeps opening automatically after code change Hi, there. I have used the solution below on how to change key pad code and it does work at the time of change. After that, the garage door ...

garage door comes down, it reopens automatically! I can't seem to find anything that is causing this. You might want to check that the sensors mounted on the side of your garage are lined up .... Also

...automatic garage door opener does not fucntion well in very cold temperatures (below 32 F). It will not close all of the way and will stop or will stop about half way down and return to the up ...

...garage door shuts then just automatically re opens there is nothing in the sensors path If it hits the floor and then reverses then you will have to first turn up the down force a little bit and try. ...

...garage door openers. Pull the release cord that unlocks the door from the opener, and manually open the door ALL the way open. Then lock back in place in the open position. Then use automatic opener ...

...garage door opener opens on it own. I have reset the code. I have replaced the batteries in the remotes. I disconnected the wall remote to confirm it was not a wiring issue Is there something in the ...