brushes will not turn (1) Remove the brushes by pulling down at the ends. Is the square pin present on the top of one brush? It should be approximately 1/4 inch square, and two inches long. That ...
Beater bar Hi,I have a hoover windtunnel supreme. I am trying to remember how to get the beater bar to work after I used the attachments. There may be a shutoff switch, located on the hood, that shuts
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
why did the brushes stop rotating? Please check two things: (1) The shutoff switch on the hood is NOT set to OFF for brush speed. (2) Remove the red filter panel from under the cleaner, behind the ...
Question about SteamVac Carpet/Upholstery Deep Cleaner Vacuum
Automatic shutoff red ball in recovery tank rises to top when recovery tank is about 20% full.Thus we are only able to use the steam cleaner for about 2 minutes before having to empty the recovery ...
Question about SteamVac F5914-900 SpinScrub Upright Vacuum
the red ball pops up periodically; why is that? The red ball is the float/shutoff for full tank. That prevents water from overflowing and being sucked in to the vacuum motor. When the float shuts off ...
Question about U6630-900 WindTunnel Bagless Upright Vacuum
My Windtunnel 2 keeps turning off after a few minutes or even seconds of use. We thought at first this was the thermal shutoff feature but this happens regardless of how long it has been turned off. ...
Question about U5753-900 WindTunnel Bagless Upright Vacuum
why does my vacuum cleaner quite working about two minutes into vacuuming? It just shuts off. I have the pet fur picker upper version Sounds like overheating of motor operating a thermal cut out ...
Question about F5866-900 SteamVac Deluxe Wet/Dry Vacuum
auto shutoff I am having a similiar problem as most but have not been able to solve the issue so far. The auto shutoff engaged...I emptied the tank and tried to continue but the brushes would not turn
Question about F5866-900 SteamVac Deluxe Wet/Dry Vacuum
How do I stop shutoff from thermal protector? Hi! The thermal protector is activated by a clog and/or a filter that needs to be cleaned or replaced.
Question about F5866-900 SteamVac Deluxe Wet/Dry Vacuum
...it is faulty or because there is not enough airflow over the motor. Overheating motor causing an automatic shutoff. This is most commonly caused by an air passage that is plugged by hair or dirt. ...
Usually answered in minutes!
746 Questions
388 Questions
262 Questions
179 Questions