...audi a3 2002 1.8 - idle rate fluctuates and the engine loses power when I accelerate. fuel filter change at last service (6 months) and I've checked all the fuses relating to engine control... any ...
Audi a4 Quattro 2.8. Battery died and we charged it fully and now it will start but it will not idle, i was told it might be a motor with in the idle. the mechanic has it now i am concerend about what
audi tt from cold and leave it to idle for about 10/15 minutes the engine cuts out because the battey runs flat, this is with no equipment turned on, it does not appear to charge at this stage,however
...Audi A4 Quattro 2.0T Idle Vibrations Hi I just bought a 2007 Audi A4 Quattro 2.0T with about 31k miles on it. The car vibrates when it's idling, is this normal? I've only owned trucks before so my ...
...idle 2003 audi A4 2.0 fsi, has misfire on idle normally worse when hot, has been to audi for over a month they cannot fix it, replaced all sensors ,coil packs,plugs, removed valves and clean , re ...
Audi 4000s. Sometimes runs normally, other times will not give me any power when I step on the gas. When idling it often idles low and almost cuts out, only to catch itself and resume its normal idle.
...idle Audi A4 1.8t car runs idled at about 800-1000 really rough idle. Has a lot of back pressure coming out of the exhaust. Any ideas? Or any questions you may have to help me figure out what's wrong ...
Question about 1986 4000 CS
...Audi A4 3.0 2003 having idle problems at times. Idles doun and back up and at times I've had problemes at intersections and taking off at times it will not go like before? Check vaccum lines vw audi ...
Question about 1986 4000 CS
Idle ' Audi-Sport.net www.audi-sport.net > ... > A3/S3/Sportback (8P Chassis) Feb 1, 2012 - My Car 58 S3, as of last night decided to start revving whilst on idle, I found a clip ... I can do or is it
Question about 1986 4000 CS
audi quattro no power idles up and down and will not idle on its own will not idle and around 1200rpm the idle goes up and down ,no power You need to have a fault code test run, that is the first step
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions