Questions & Answers for: GMC Jimmy arc 160

wont start when its wet outside its not the distributor cap and rotor or the coil pack check the coil wire. If routed to close to the trans dip stick tube it will arc

willnot start pulled starter bench tested ok willnot start pulled starter bench tested ok battery good Check all cables to the starter and the ground or negative cable from the battery to the engine ...

The Motor is missing, more at low idle There are LOTS of possibilities, the most common ones are ignition related. Without knowing more about what engine and ignition system you have, I can only give ...

...work until you try to start, The starter will draw a lot of juice and cause the loose terminal to arc and lose connection. Now if this was happening before you replaced the battery then it may be ...

I have a 1995 gmc jimmy. Fuel injected 4.3 vortec. I need to clean out the egr valve but I have not been able to locate it. Can some one please help! If you have photos that would really help Sorry I ...

looking for intake torque sequence Lower intake torque is done in three steps:Step 1&#160;&#160;&#160; 27 in. lbsStep 2&#160;&#160;&#160; 106 in. lbsStep 3&#160;&#160;&#160; 133 in. lbsSequence is:<

try having someone start it at night while you look at the various parts of the ignition system for arcing.&#160; The carbon tracking is not always visible but the arcs reveal a great deal at night.If

2000 gmc jimmy 4.3 4wd rolls over lots of spark no gas being delivered turn key on hear pump sometimes,and when i turn key off Filter could be clogged. &#160;Try changing it.&#160; &#160; &#160; &#160

...sounds like its runnung on 2 cylinders. rpms jump all over and keeps stalling out, i think i hear a arc but cant pinpoint it Check fuel pressure, fuel injectors and spark plug ...

...the coil to reveal a tiny break in the wire, while the engine is running the gap will continue to arc across, but fail to connect after shutting down the engine. once the coil cools the wiring ...