my tv i have a zenith r57w46 and it comes on for a sec.and then gos off,what do i do to fix it??? best thing to do is look for ant popping sound or arcing, check the bottom of the circut boards for ...
Question about R40W46 40" Rear Projection HDTV-Ready Television
my tv has very similar problem,arced red lines and ghost lines. how do i check my resistors? where can i buy the parts i need? oh and where is the board located in my tv r56w36 zenith crt projection ...
Question about IQC50H94W 50" Rear Projection Television
I have a Zenith Projection 50" TV IQC50H94W that has a blue arc Our TV has a Blue arc on the bottom of the screen that you can see when its in video mode. On regular channels you see blue also. I ...
Question about R57W46 57" Rear Projection Television
series of red laser like lines across the TV screen causing blurry images and duplicate words in an arc like fashion It probably needs the convergence circuit repaired by a qualified technician
Question about R40W46 40" Rear Projection HDTV-Ready Television
When the lamp goes out, is the a burning smell and a crackling noise when tv is turned on? Flyback or the HV wires are arcing, and will need replacement Flyback is most likliest of the two But will ...
when I plug in my 36" Zenith TV the screen stays black, a clicking and popping noise comes from the back and I smell acrid smoke like from an electrical fire. What is going on, and is it repairable? ...
Question about B36A24Z 36" TV
What can cause a burned capacitor cx3210 and melted degauser disc in Zenith B36A24Z Can dirt cause this problem from overheating or arcing? This problem has been answered.
Question about B36A24Z 36" TV
...and melted thermister thx3415 in Zenith B36A24Z Can dirt cause this problem from overheating or arcing? There was a large amount of dust on the board and tube. When more dust accumulate, and ...
...EHT boot cap for damage. 160;Contact any experienced service technician. 160;Extra High Tension arcing is160;going160;on inside. 160;Do not turn ON this TV, until the fault has been ...
Question about R56W36 56" Rear Projection Television
...likely what you have now is the seal they place where the wire enters the tube (2nd Anode) is arcing.tube has to be removed to get at and reseal that--not a beginner or doit yourself ...
Usually answered in minutes!
269 Questions
273 Questions
232 Questions
195 Questions
159 Questions