Question about Lincoln Welding Tools
160;.....also the rhostat has a wire that goes to the pc board and as u strike a arc it idles the welder up When welding with large rods,after about a 1-inch pass the arc skips and starts back welding
...arc Check to make sure there is an open circuit voltage across the ground lead and the welding tip.  Open circuit can vary from 18 to about 40 volts.If you do not see that, open it up and check ...
...arc 250, Model# 250-250, Code # 9041, would like to download to my computer http://www.lincolnelectric.com/en-us/support/Pages/operator-manuals.aspxThe basic cathederal top with the round crank to ...
...tube near the firewall.Worst case- try cranking it at night in the dark to see if you have any
Usually answered in minutes!
49 Questions
39 Questions
24 Questions
