Questions & Answers for: anti skate

...is gone and therefore the needle isn't holding to the grooves rather than a tracking weight or anti skate problem. [email protected] hi, take a WD40 spray it gently on the part of the

...anti skate setting at the back of the turn table, a round adjustable bit with numbers, increase the anti skate and then use the balance weigth (weight right at the back of the arm that turns to get ...

record; doesn't engage grooves stylus "skates" across record when turntable is turned on (new at-lp2D-usb turntable, just assembled). Increase the weight of the arm, check if it has anti-skate control

...anti - skate and tone arm hight on my turntables what are the proper specs, thanks. Anti skate should be set the same as the weight, i.e 3 gram of weight = 3 on the anti skate. ...

...anti skate spring is busted I think? Need somewhere in Australia, preferably brisbane. The anti skate spring is not part of the arm assy but can be obtained separatly. ...

...anti skate weight system has a fault,it drags the arm toward the center of the record faster than needed.there is also a weight on the back of the arm.that is the balance.when set to zero,the arm ...

anti skate also the couter wait. nothing seems to solve it. At the moment i am using a 1 p o Oh yeh im using 1210s Has the tip  broken off the stylus? If the needle is good and skipping backwards

...anti-skate on the stanton t62? Where is the anti-skate device on the stanton t62? There is no skate adjustment! The anti skate adjuster is located at the base of the tone arm. (if you have one). Most ...

anti skate anti-skating doesn't work properly On the early (pre 2017) versions, the anti-skate spring was too weak. To overcome this issue, you either need to cut off about a third of the existing ...

an odd record then skips a few grooves on a good condition record, you can adjust the Anti skate control to prevent it. Adjustment it is like setting the stylus pressure, a question of trial and error