Questions & Answers for: Honda VTX 1300 Retro anti rattle spring

Ad

What would cause the speedometer to start bouceing around when driving? I had this happen on my 03 VTX which later lead to it going completely dead. My problem was he ground lead on the batter was not

Ad

Question about 2003 VTX 1300 Retro

1 Answer

How to replace front wheen brake pads Push the Caliper piston all the way in to allow installation of new brake pads by pushing the caliper body inward. Remove the pad pin plug and loosen the pad pin.

Ad

Question about 2003 VTX 1300 Retro

1 Answer

I had to loosen the front shock to remove the front fender. ( New paint job). I unscrewed the top cap and released the spring. Now the threads are down in the tube to far to reach. How do I get them ...

My 2007 VTX 1300 Retro started sputtering, lost acceleration, top speed dropped to 70? Bike has 8200 miles. When I bought it about 2 months ago it had around 7300. Had been setting up. Ran good but ...

scraping noise sometimes when going over a dip on vtx 1300 I hear kinda of a scraping noise just sometimes at random when going over a dip or bump from the rear of the bike....any suggestions? @ Hi, ...

Question about 2003 VTX 1300 Retro

1 Answer

...anti-rattle clips fell out where do they go@ Hi, Lewis for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Honda, ...

Question about 2003 VTX 1300 Retro

1 Answer

adjust air fuel mixture Hi, Anonymous it should be noted that the "AIR FUEL" mixture screw adjustment "ONLY" manages your idle and has no effect on any other circuit also any intake leaks must be ...

2003 Honda VTX 1300 starts fine but stalls when you shift into 1st Hi, Anonymous and the usual suspects are: 1. Faulty wiring to any safety switch. 2. Safety switches loose at the mounting point. 3. ...

2003 vtx 1300 starts fine dies when shifted into gear Hi, Anonymous and the usual suspects are: 1. Faulty wiring to any safety switch. 2. Safety switches loose at the mounting point. 3. Faulty ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...