Questions & Answers for: Harley Davidson FLHTC Electra Glide Classic anti rattle spring

Ad

Question about 2003 FLHTC Electra Glide Classic

1 Answer

Purchased a york hydraulic primary chain tensioner for my 2005 HD vtwin and it came with no instructions. Believe I have it installed correctly but any particulars for adjustments I need to know about

Ad

Question about 2003 FLHTC Electra Glide Classic

1 Answer

replaced clutch, oil, cables...1998 electra glide classic..bike is hard to get into neutral once it is warmed up.. Make sure you do not overfill the primary. when putting the oil in the primary, have ...

Ad

Question about 2003 FLHTC Electra Glide Classic

1 Answer

1980 FLH pushrods, took hours to get out because bottom of rods still in hyrollic cup. I've determined that rockerarm is pushing down farther on rod then before on both heads. Have worked with ...

Question about 2003 FLHTC Electra Glide Classic

1 Answer

cant find the idle skrew Look at the carb while you move the throttle and you will see on the carb all the moving .parts. The idle screw will bump up against a moving tab. Take you time and you will ...

Question about 2003 FLHTC Electra Glide Classic

1 Answer

internal schematic of 71640-99 ignition switch? Is the copper contacts that set on top of three small springs on each side supposed to be separated in middle or does this mean it's broke? sounds ...

Question about 2009 FLHTC Electra Glide Classic

1 Answer

can actually move the pad with my finger. Ive taken them off 3 times but can't figure it out. Hi Tdg1263, you left out the anti rattle spring clip OEM part # 42852-06A. Good luck and have nice day

harley wanting to stall at low idel and misfiring ,engin light flashes on and off runs fine on freeway mostley stock only after market pipes Hi Anonymous, and the usual suspects are: 1. Spark plugs in

What is the rattling thats coming from behind the primary cover in nuetral? Clutch engauged or disengauged While idling in neutral the bike has developed a rattle behind the primary cover, clutch ...

1988 FLHTC E-Glide. What is the torque spec for the 4 bolts holding the clutch assembly (diaphragm spring, friction and steel plates) to the clutch basket?? Hi Thomas, it's 8 ft lbs. but there are ...

Question about 2010 FLHTC Electra Glide Classic

1 Answer

Torque on clutch for 2001 electra glide classic Hi Johny, Diaphram spring bolts 10 ft lbs. Clutch hub nut 75 ft lbs. Have nice day.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...