Hammer switch jammed on Makita HP1621K/2 Percussion Drill 2 Hi, I've had this Makita Percussion Drill for 1 1/2 years. A few days ago, after a fairly long drilling session to put some shelves up, the ...
Slide mechanism jammed I have a Ryobi dompound slide mitre saw (don't know model no.) and both rails are a bit rusted, I went to use it the other day and the slide mechanism is jammed - doesn't seem ...
Makita Circular saw 5007NB, the cutting depth guide is jammed. What can I do? you can try spraying some lubricant on the bolt/roll pin and see if that frees it up that is about all i used to do to ...
Question about 10" Dual Bevel Sliding Compound Miter Saw
my LS1216 slide compound miter saws mitering table is stuck at 0 degrees it appears jammed although I've looked for something jammed stopping the plate from moving and see nothing, the handle locking ...
have followed instructions for my makita chuck change removed screw tuned anti clockwise but will still not come off I have detailed instructions on my tip page that should remedy the problem. Let me ...
My Makita AF 505 brad nailer had been working fine in the past. After sitting for about 2 months I'm using it again however the nails are now jamming all the time. The nail ends up bent after ...
...the work surface. Put the chuck key into the chuck and give it a hard blow so you knock it in an anti clockwise direction. If it is a keyless chuck or you don't have a key try holding the short
Question about LS1016LX 10inch DualSlide Miter Saw with Laser and Stand
...and not pressed. I'm at a loss. Thanks. try a squirt of wd-40 or crc to free up the button. The anti rust spray used in assembly has probably got sticky and is jamming the shaft of the button Oil ...
Question about 10" Miter Saw LS1030N
the cutting disc on my makita 5806b spins anti clockwise causing damage if i cut laminate from the top and i need it to spin clockwise You could turn the laminate over. The proper tools would be ...
Makita XPH01 chuck & motor are jammed Drilling a self tapping screw and when it was in I tried to do another one and nothing happens, the light comes on but the chuck does not turn even by hand I ...
Usually answered in minutes!
104 Questions
75 Questions
18 Questions