Questions & Answers for: antenna mast Cars & Trucks

...antenna mast is no good.. you can buy a mast and have it installed or buy a used antenna and have it installed im sure Elite foreign auto parts has only saab parts.. tested and used, sounds like ...

Antenna mast broken How to replace power antenna mast on 1993 Corvette? Replacement mast kit I have does not contain instructions. Different sites show instructions for removing antenna motor and old ...

...Antenna mast Mast, Power NOTE: A power antenna mast which is bent or broken can be replaced without replacing the motor and tube assembly. Removal Remove radio antenna nut (18865) and radio antenna ...

...antenna mast. Gain access to the underside of the area of the trunk where the antenna is located. Remove the bracket or brace that is below the hole and holding the antenna in place. Remove the mast. ...

...Antenna Mast 1988 LeBaron power antenna mast broken. Motor still functional. Would rather replace with permanent single mast, but willing to replace power mast. Which is easiest, which is most ...

antenna mast is the type where you can unscrew the mast from the fender, simply do so with a pair of pliers. Most damaged antennas are simply the result of a truck wash or similar mishap, in which the

...antenna mast and cable" I replaced mine 4 years ago for 34.00 on Ebay. you might do a search on CORVETTE Power Antenna MAST 1988-1992 + How 2 They have it for $21.99 + $5.00 shipping. Or just search ...

...antenna mast starting in October 2005. The radio antenna base size increased from 6 mm (0.23 in) to 7 mm (0.27 in) for improved stability and radio reception. There are two different design antenna ...

...antenna mast will not go down completely, withdraw antenna and cable. Cut just enough cable off the new mast (small amounts at a time), to allow the mast to retract fully. DO NOT CUT TOO MUCH OFF. 8) ...

...antenna mast with broken cord will not come out after the chrome nut is removed. Any suggestions? Antenna motor still works. Power Antenna Mast Replacement 97 fjz-80 ' IH8MUD Forum forum.ih8mud.com > ...