...antenna mast and rack be replaced in thi factory unit and is it difficult. Most power antennas are an easy thing to remove you just need to be able to get to the bottom to undo the nut holding it and ...
...antenna? Should be a dome light in the interior that lines up with antennae on roof if it's same as I remember. Remove interior light and there should be screws in there holding base of antennae to ...
...antenna mast on a 2005 Ford focus I broke the antenna mast off of my 2005 Ford Focus I have bought the replacement parts but I need to know how to get the mount off to replace it as the stud that ...
...antenna mast from the base. unscrw counterclocwise Detach the interior light. Remove the interior lamp. Disconnect the interior light electrical connector. Remove the interior lamp bezel. Remove the ...
...Antenna mast Mast, Power NOTE: A power antenna mast which is bent or broken can be replaced without replacing the motor and tube assembly. Removal Remove radio antenna nut (18865) and radio antenna ...
how do I replace the antennae mast on a 1988 Taurus? look at the base of the mast, if it has two flats on it you can put a vise grip on it and unscrew it. if not you are going to have to remove the ...
Question about 2012 Fusion S Sedan 2.5L 4-cyl. 6-speed Manual
...and hit the edge of my windshield right where the radio antennae grid is embedded and now the radio won't come on. obviously , replace windsheild or install new antenna mast
Question about 2012 Fusion S Sedan 2.5L 4-cyl. 6-speed Manual
...antenna removel How too Power antennas require two people to replace. watch old mast as radio is turned on and off, then remove retainer nut and parts turn on and assist old mast out watching the ...
Question about 2012 Fusion S Sedan 2.5L 4-cyl. 6-speed Manual
...antenna mast lube with machine oil 3 and 1 works great then slowly feed new mast into motor assembly then turn radio off as you guide new mast down install retainer parts work antenna up and down ...
...antenna mast goes through then have them turn radio on again this you assist the rest of the mast out of motor assembly watching what side the teeth are on the plastic cable . Now take new mast and ...
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions