Questions & Answers for: antenna base

Question about 2007 Yukon Denali

1 Answer

...the antenna base the antenna baseon my truck is located above the front fender under the wheel arch there is normally a splash guard this must be removed so as to get at the base of the antenna . ...

Ad

Question about 2002 Yukon XL

1 Answer

...antenna base the antenna baseon my truck is located above the front fender antenna snapped off taking screw piece with it from base so I need a new antenna and base. When I get the parts how do I ...

Ad

...Antenna Base Removal Remove the antenna mast from the base. unscrw counterclocwise Detach the interior light. Remove the interior lamp. Disconnect the interior light electrical connector. Remove the ...

...antenna base. And pull the cable towards you - out from the door hinge area into the fender area. Good Luck! Installation is reverse of above. If this helped or you need clarification or additional ...

Question about SIRPNP2 SIRIUS Radio Receiver

1 Answer

...base and antenna don't solve it, then the radio is shot and it's time for a new one. Customer service will ususally give you a great deal on a new XM radio IF you agree to keep it for 1 year. Let me ...

Question about SIRPNP2 SIRIUS Radio Receiver

1 Answer

...antenna base equipped with the vehicle  Poor ground at the antenna base or radio  Poor battery ground to chassis or engine  Poor antenna cable connection at Radio ...

...antenna base and the place where you put the antenna. Any other antenna; check the place where the whip goes into the coil at base of the antenna. Make sure that antenna has good ground. Check ...

Question about 2000 F150 Flareside SuperCab

1 Answer

antenna base. Remove the radio antenna base cap (18A927) by gently inserting a thin straight-edged screwdriver underneath the cap and carefully following inside the perimeter until both snaps are free

Question about 2000 F150 Flareside SuperCab

1 Answer

...antenna base. If the antenna mast is extended, pull it down until it clicks into place. If the antenna mast is retracted, turn the antenna base clockwise to extend it. Tighten the antenna base to ...

antenna base. Grasp the antenna mast near its base and twist it counterclockwise to remove it from the base. Remove the antenna base cover. You can use a flathead screwdriver or a plastic trim removal

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...