...throttle/gas pedal was not stiff before attempting to start. I suspect something amiss inside the carb. The connecting pedal to carb cable is OK as I can see it moving on the carb. There is a strong ...
...amp; INSTALLATION Disconnect the negative battery cable. Disconnect the cable which runs from the starter to the battery at the battery end. If necessary, remove the air cleaner assembly in order to ...
carb. Look down the carb while pumping the throttle linkage, if it is squirting a good stream, your good , if not the pump or the little black rubber cover on the top of the pump is bad. worked for me
...throttle linkage side) this engine is in a local built jeep in the philippines. It goes into the center hole it is longer than the other two tehe two sidescrews just holds the base plateon the third ...
hard gas pedal when taking off You may need to spray some WD-40 on the throttle cable and throttle body linkage. Also check inside the throttle body for carbon build up by the throttle plate and clean
...amp; INSTALLATION (see Figure 1) Disconnect the negative battery cable. Remove the door panel and watershield. Remove the service hole cover. Disconnect the door outside opening linkage. Remove the ...
starts good, takes throttle, no idle. Hello, You may have idle jet is get problem or vacuum leaks. For temporary remedy, use a carburetor cleaner to clean your carburetor and found the vacuum ...
throttle cable linkage what about it?
...totl loss of 5th and recerse Automatic--it has to come out & be rebuilt Standard transaxle--may have to come out & apart to replace the sychro rings or other internal issues Check linkage ...
...amp; failed part, the is cause the main concern Hi Since pump and throttle have been replaced this may be an electrical pronlem. Please check whether power is on in the pump always or it is getting ...
Usually answered in minutes!
1,231 Questions
1,240 Questions
1,236 Questions
819 Questions
767 Questions