Questions & Answers for: Kohler amp throttle linkage

Ad

Question about CH25 PA-CH730-0040 Command Gasoline Engine

1 Answer

throttle as if the governer was stuck. does this 15 hp engine have an external governer or is it built into the engine? My JD with 15 hp Kohler did the same thing. You will need to pull the air filter

Ad

Question about CH25 PA-CH730-0040 Command Gasoline Engine

3 Answers

...throttle after a minute or two engine dies, but if choke is placed on, engine will continue running for another minute then dies. Will not hot restart, but 15 minutes later will start up fine. Had a ...

Ad

Question about CH25 PA-CH730-0040 Command Gasoline Engine

1 Answer

...throttle down at all, but will run roughly choked. What is the issue here? HAVE YOU CHECKED THE CARB AT ALL? LOOK AT THE LINKAGE & MAKE SURE IT MOVES FREELY! IF CARB CHECKS OUT MAKE SURE GOVENER ...

Question about CH25 PA-CH730-0040 Command Gasoline Engine

1 Answer

...for a small rod that should be attached to the carb under the throttle linkage. If missing altogether you may only find small arm with a hole in it where it should be, If unsure, consult mower

Question about CH25 PA-CH730-0040 Command Gasoline Engine

1 Answer

throttle by hand it starts running for a couple seconds, but then LED 2 & LED 1 come on and it shuts down. LED 5 comes on while the engine is shutting down. Any ideas?? i got the same gen and with

Question about CH25 PA-CH730-0040 Command Gasoline Engine

1 Answer

off the carb bore. Often the actuating mechanism slips on the shaft on aome motors due to a loose clamp

Question about CH25 PA-CH730-0040 Command Gasoline Engine

1 Answer

I am removing a Kohler engine from a simplicity lawn tractor. I was told that the govenor gear inside the engine is not working because the engine just started racing (RPM's) I check teh linkage and ...

Question about 12 kW Emergency Power System - 12RES-L

1 Answer

throttle linkage by hand back and forth fully as sometimes the 17, 18, and 20 butterfly valve sticks on the carburetor gasket. If this happens, remove the gasket and use a file to put a good bevel (45

When I try to lower engine rpm by retarding the throttle control to idle the engine speed does not change? Your throttle cable is screwed up , you can probably fix it without buying anything. It ...

Question about 20 Hp OHV Command V-Twin Engine Exmark Navigator-ZTR-Comm.R

1 Answer

the egine runs to fast wih a touch the throttle,what causes that/ does the engine idle when throttling down,if not you may have a worn governor or incorrect spring and or linkage settings.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kohler Electrical Supply Experts

Sheldon Dedek

Level 3 Expert

909 Answers

rjivaro

Level 2 Expert

158 Answers

J. Bradshaw

Level 2 Expert

121 Answers

Are you a Kohler Electrical Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...