Questions & Answers for: kawasaki amp throttle linkage


Question about 2001 EL 250 Eliminator V

1 Answer

...throttle linkage on the carb you will see which of the mounting holes rises and which goes the oppisite way. normally the front 1 is the pull and the rear is the push. do the same on the cables by ...


Question about 1990 VN 750 Vulcan

2 Answers

...throttle on the handle bars? thank you. no spring in the grip! id suspect the cables are binding up inside so disconnect at the carby end then & see if they are moving freely Cheers Rob Un hook. ...


Need to adjust the throttle on a 2000 Kawasaki KX250 Hi, there I just bought a 2000 Kawasaki kx250 and I'm wondering if there should be a breather hose for the engine for the oil there. It drains out ...

...throttle, it takes forever to come back down to a normal idle. does this going down the road, which i feel is dangerous. What is causing this? I have thoroughly gone through the carbs, jets, lubed ...

...throttle linkage itself. If it snaps back into place, it is the cable not the carbs. If it does not snap back, lube the linkage at each carburetor while moving it and see if it frees up.Fourth, if it ...

...Cable Replacement Kawasaki Vulcan Forum Vulcan Forums kawasaki vulcan 500 carburetor throttle linkage and cables Kawasaki EN500 Service Manual OEM Parts for Kawasaki ...

why does my atv runs at fast idle at all times check your throttle cables,may need lubrication,especially near carb linkages,clean &lubricate,no wd-40.

...linkage for the gas throttle had a lot of dirt on it and would not let the throttle close completely. So when I shut off the warm engine, gas leaked into the cylinder. It would take a lot of cranking ...

linkage to make sure it's working? It may have a loose clamp or screw, and even though you think you're choking it, you're not. Another thing, some of these bikes don't like throttle with a cold start

17hp kawasaki idels fine but when you throttle up it runs wide open just put governor in Eric, the one thing I can think of is that either your linkages are incorrect, by that I mean it sounds as if ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5968 Answers


Level 3 Expert

85216 Answers


Level 3 Expert

858 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides