...remote wire go from the amp to the battery (Which does not have any juice when checked with a tester) or what. Thanks. The Remote wire should connect to the remote turn on lead from you radio(most ...
...time you insert a cd this remote wire,the pwr cut out. BLUE/WHITE STRIPE This is the AMP REMOTE WIRE,THIS IS THE REMOTE WIRE THAT YOU NEED TO CONNECT TO THE AMP LET ME KNOW IF IT WORKS ...
...amp. +12v, ground and remote. ensure the remote is connect to the remote of the player or preamp. if the remote aint connected there will be no power on the amp.. if yor radio or player dont have a ...
Question about UL-1600M Car Audio Amplifier
...amp. Without the remote wire hook up the amp will not turn on. Reason for this is, the Head Unit tells the AMP to turn on, without the remote connected the AMP is going to do nothing, find the remote ...
Question about ZX300.1 Car Audio Amplifier
amp does not turn off with the remote wire removed, there is probably a short between the 12V+ and remote terminals. In that case, the amp is probably defective. If it is OK otherwise, you could still
...amp Hi if you have a amp the blue remote wire goes to the remote turn on terminal or wire on the amp. If you do not have an amp, cap the remote wire you will not need it. Thank you for using ...
amp and the remote turn on connector of the amp. If the amp powers on there is an issue with the remote turn on connection either a bad wire or bad output. If the amp doesn't turn on there is an issue
...port on the amp. The remote wire turns your amp on when turning ignition on and turns amp off when turning ignition off. This wire needs to be connected as without it, you will drain your
...remote amp turn on, they are usually less than 1 amp. If you over amp the remote wire, the amp will have to be repaired. Usually on aftermarket decks, the remote wire is blue. What make and model is ...
Question about LXA300 Car Audio Amplifier
remote amp wire. Also check your amp ground. Infact first bridge your 12v amp + wire to the remote wire with some pliers or a short wire and see if the amp comes on. That will make sure the amp is not
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions