Questions & Answers for: Ford Explorer alternator belt

...ALTERNATOR BELT BROKE I HAD IT REPLACED NOW MY CAR WILL NOT START. its a small possibility but i seen remanufactured alternators that have too much drag on the motor( resistance) so the engine cant ...

drive belt and install the drive belt on the alternator pulley. Connect the negative battery cable. Good luck and hope this helps, Start the engine and check for proper charging system operation. 

...alternator. 3. remove serpentine belt by loosening the adjusting bolt and the idler pulley nut at right of the engine. 4. remove two bolts holding the alternator then remove the alternator from the ...

...belt off the alternator pulley.You need to then take the 13mm bolts from the bottom and the one from the top of the alternator and it's of the truck.All this being done after the negative cable was ...

...the same thing is the alternator (you should also see the battery light on the dash). If the battery and alternator test good it could also be belt related from a bad belt tensioner or a missing

...alternator pulley. The new belt won't be stretched out, and it is not uncommon to have slide it on just right to get it to fit. It took me about 15 minutes to get one of my belts on (and hour to get ...

...belt is ok, then more then likely the alternator has gone bad, if you can jump start your engine, check voltage at battery with engine running and jumper cable's remove, with volt meter check voltage ...

...Alternator belt( turns the pulley on the alternator to make the alternator produce voltage) Belt tensioner( a spring force if the tensioner keeps the belt pulled tight. so it does not slip when the ...

...alternator,pull to relieve tension on belt and remove belt from alt. Remember how the belt is routed.If you are not going to replace the belt then after getting it off the alt keep tension on it ,so ...

...belt it can be removed from the alternator pulley. You do not need to remove the entire belt. Remove the three bolts holding the alternator to the bracket. A 15mm socket and possible a swivel should ...