...alternator on 98 chevy metro 4 cylinder dont know a whole lot about it my uncle is replacing it Disconnect the negative (-) battery cable. CAUTION: Failure to observe Step 1 may result in a serious ...
alternator belt. If the noise is gone, we can safely assume it's the alternator. When replacing the alternator belt, make sure you're not tightening it too tight - that will cause a noise and ruin the
What two belts are on the passager side of the engine These two belts should be for the alternator, power steering, water pump, emissions, and the a/c compressor.
...some more after a day or two if the belt is skipping. Not very good for a new belt tho... If the alternator moves hard, you can probably use a lever, but be careful not to press on a fragile
...alternator belt and adjust the tension until a deflection of 0.24-0.31 inch (6-8mm) deflection with 22 lbs. (10 kg) of pressure exerted when installing a used belt. On a new belt the belt deflection ...
...alternator on a 2001 Chevy Metro LSI and now I cannot seem to achieve proper belt tension, the belt squeaks very loudly, I applied belt dressing and tried several settings of tight and loose tension ...
belt Lower alternator cover plate Water pump/alternator drive belt Crankshaft pulley Water pump pulley Timing belt Dipstick tube Upper alternator bracket from the water pump Water pump and discard the
belt in a chevy metro 2001 mechanic replaced alternator and timing belts, says the squeal can be fixed by cutting the a/c belt...where is it? the a/c belt is the smal belt that goes to the
Alternator belt slip? your belt is worn or someing is trying to lock up
Usually answered in minutes!
95 Questions
76 Questions
69 Questions
67 Questions