Questions & Answers for: Buick Skylark alternator belt

belt removal and suspect idler pulley bearing there is going to be a tensioner pulley near the front of the motor on top that you have to apply pressure to or you can loosen the alternator and take it

...that the serpentine belt that spins the alternator, is well in place and well in tension. If the serpentine belt is not spinning the alternator adequately, that will cause the battery not to

...it has a tensioner, it look like a useless pully and put a breaker bar on it and pull it and the belt should loosen up, if theres no tensioner the alternator should have bolts to loosen up the

...belt to remove and install the water pump? I think I located the tensioner below the alternator pulley? Do i need a special tool? on the bottom there is a tension pully u can adjust it from ...

...Alternator-Put your fan back on-now put All your Drive belts back on be sure to Adjust the Belt Tension and Lock down the Bolts.-Fill your Radiator back up with coolant,If the Fluid you took out is ...

...belt off the alternator pulley. Step 4. Locate and disconnect all the mounting bolts on the alternator, use a vehicle specific manual if you have any trouble. Step 5. Disconnect all wires attached to ...

I am putting in a new alternator,and now I cannot figure out the belt sequence on all the pulleys try looking here http://www.2carpros.com/car_repair_information/index.htm

belt. The alternator is held in place by two bolts and one will require a 13 mm socket to remove it and the other one requires a 13 mm wrench to remove the nuts while holding the long bolt with either

...bolt mount back in place. Release jack or lift. I usually put belt back on everything but alternator, pull on tensioner and roll back over alternator. This is on a 3100 engine, or 3.1 liter. good ...

...belt from the alternator pulley 3. remove 2 alternator retaining bolts on either side of pulley 4. disconnect pos. and neg. battery connectors 5. remove alternator installation is the reverse of ...