Question about 80754 Top Load Stacked Washer / Dryer
...swing it back over the rear of the unit. On either side of the top, you will see a gold latch. Put a regular screwdriver in the groove along the front of these latches, down in the hole in the top, ...
Question about 15208 Mechanical Sewing Machine
along, or did you let the machine feed it itself? Pulling it through can cause needles to flex and hit the hook area incorrectly, causing the machine to go out of time. Now, if the needle is not going
...along the back on the console base. Remove these to make install easier later, I use a step ladder or if you have a nice laundry just pull the machine out and do the work from the back. After removal ...
...the top panel by pushing in on the release tabs. This is accomplished by inserting a putty knife along the seam where the top meets the front about two inched in from each side. Push in while ...
...swing forward into the washer front. Re-install the rear counter-weight and washer back brackets. 6. Re-install the washer support shocks. 7. Re-install the drain line hose. 8. Re-install the Motor ...
Question about Elite 45986 Front Load Washer
...along the top crack above the door on the front of the dryer. You should encounter a release pin about three inches in from each edge. Push the pins in to release the top panel and it should swing up ...
...swing forward into the washer front. Re-install the rear counter-weight and washer back brackets. 6. Re-install the washer support shocks. 7. Re-install the drain line hose. 8. Re-install the Motor ...
Question about Elite 45986 Front Load Washer
...swing forward into the washer front. Re-install the rear counter-weight and washer back brackets. 6. Re-install the washer support shocks. 7. Re-install the drain line hose. 8. Re-install the Motor ...
...swing forward into the washer front. Re-install the rear counter-weight and washer back brackets. 6. Re-install the washer support shocks. 7. Re-install the drain line hose. 8. Re-install the Motor ...
...change the front door swing....would you be able to pass along the instructions to do that? Unfortunately the door swing on this model is not reversible. Any further questions please feel free to
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions