...needle bounces back and forth too badly to get an accurate measurement. Bought used, clean on outside, everything else seems to work correctly, original mic. Don't worry about the meter in the radio. ...
...align it. I am trying to help out my 89 year old mother in law. make sure the needle is positioned correctly and all the way up into the deedle slot. lower by hand and check again, if still doing so ...
align the sewing head since there is no sewing head alignment in a 900 series Huskylock ( or any Huskylock that I know of). The upper adjustments are needle bar height and needle bar twist. As long as
...needle in place. Remove the old/broken needle, paying close attention to the needle's alignment (which direction is the flat side of the shaft facing) Insert the new needle with the
Question about CS6000i Computerized Sewing Machine
Needle not aligned with hole in presser foot I just received my machine yesterday (ordered from Amazon). The presser foot was loose in the box when I opened it. I reattached, but the whole needle ...
Question about CS6000i Computerized Sewing Machine
needle do not align up together. I have tried for over one hour while looking at video tutorials and reading the manual. My husband also tried. We both believe the threader and needle eye to not align
Question about CS6000i Computerized Sewing Machine
...doing free motion quilting. Changed needle, rethreaded machine and bobbin. ck your bobbin plate alignment if it got bent while free handing and needle came down and bent/broke then theres a good ...
Question about CS6000i Computerized Sewing Machine
The needle keep on breaking because it stich on the plate Your needle alignment may need to be adjusted. Sometimes this happens if you pull the material rather than let the machine feed it. I took my ...
Question about CS6000i Computerized Sewing Machine
...up the bottom thread but stitch is not formed. I have a Ming Hui sewing machine. The hook- needle alignment was off and so I aligned it. Now the hook is going through the loop and top thread is ...
...align the foot: Try re-aligning the foot so that it is properly aligned with the needle. This can be done by adjusting the screw on the foot. Contact the seller: If the above steps do not resolve the ...
Usually answered in minutes!
980 Questions
644 Questions
497 Questions
317 Questions
274 Questions