Questions & Answers for: Chevrolet Venture air mass sensor

...and check all the onnections to sensors such as, vehcile speed control sensor, mass air flow sensor, crankshaft position sensor, camshaft poition sensor, throttle position sensor, etc. Good

...Mass Air Flow (MAF) Circuit Low Input check the wireing, make shure theres a good connections you said that you already replaced this sensor so im going to recomend that you go after the other code ...

...air mass sensor checked out, if these fail the car will start but then cut out straight away. the air mass sensor measures the correct amount of air to mix with the fuel. if they are faulty then they ...

...Mass Air Flow) sensor. The MAF sensor could be dirty or faulty, and there might even be restricted air flow to the MAF sensor (like a plugged up air filter). Also be sure that there are no air or ...

...mass air flow sensor . Don't know what kind of mechanic you take it to , but i would try another one . Hooking up a scan tool an viewing engine sensor data while it's acting up , seeing which sensor ...

what does code mean? po171 Lean mixture detected at oxygen sensor (bank1)  Remove mass air flow sensor (MAF) and spray clean with electrical or tuner cleaner. Most times that's all it takes.

...mass air flow sensor and still can't figure it out. We have put it on 3 different scanners and all same the same thing but nothing seems to be working. Does anyone else have this problem? In ...

...long as I'm giving it gas, so it drove well enough to get home. Tried cleaning & even replacing the mass air flow sensor which did nothing. fuel filter,dirty throtle body,air

mass air flow sensor, replaced oxygen sensor You could be low on motor oil or you could have sludge build up. You should change your oil regularly. ----------------------------------------------------

...mass air sensor ok Don't have a lot of experience with this model , but , sounds like rev limiter is engaging because computer believes vehicle not moving maybe ? Is speedo working if electric ? if ...