Questions & Answers for: Chevrolet Impala air mass sensor

Question about 1996 Impala SS

2 Answers

...mass air flow sensor. it is malfunctioning at this point. the mass air flow sensor Measures the volume and density of air entering the engine, so the electronic control module can determine how much ...

Ad

...Mass air flow sensor needs to be cleaned, this is located in the air intake a couple of wires come off of it.. go to the auto store and get some Mass air flow cleaner and spray it clean this should ...

Ad

Question about 2002 Impala

1 Answer

...mass air flo sensor,then throttle positioning sensor ,then if ther is a chk engine light on you can start there by extracting a code but these sensors have to do with all your symptoms so look into ...

...Mass Air Flow Sensor is bad on a 2001 Chevy Impala the mass air flow sensor has gone bad, and your needing to buy a new one It needs replacing.I have found a link so you can at least look at the ...

Question about 2000 Impala

1 Answer

...mass air flow sensor i want to do it myself the guy at auto zone said it was easy i have a 2000 impala 3.8 3.8L EngineTo Remove: MAF Location Disconnect the battery ground cable. Remove the fuel ...

Question about 2000 Impala

1 Answer

mass air flow sensor code came up on my 2002 Impala. I just had the car repainted, could the paint smell cause this sensor? No. Your air flow sensor cannot smell....it can only measure air flow. Clear

...mass air flow sensor or fuel pump what can it be?? I have a 2000 Chevy Impala and my car only stay crank if my foot is on the gas, when I release , it shuts off. It's not the mass air flow ...

Question about 2000 Impala

1 Answer

...mass air flow sensor and it does the same thing unless i olso replaced the mass airflow connector,, the funny thing is that if i disconnect the signal wire from the mass airflow sensor the ...

...mass air sensor. I changed it and turned off the light. it was still doing the same thing so I changed it again to make sure I didn't buy a defective one. Same problem. Any Ideas? check the wiring ...

Mass Air Flow sensor range code. It says the MAF sensor read lower than expected under certain conditions that the computer knows based on other sensors at the exact same time (RPM, TPS, MAP, VSS etc)

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...