Questions & Answers for: Dodge Neon adjusting the belt

...set belt tension to 135 lb. click here for picture 1 click here for picture 2 Dont forget to unloosten the 15mm fulcrum bolt in addition to the two adjusting bolts or the bracket will not adjust. ...

Ad

how to replace belt tension pulley for dodge neon 2002 how to do i pull the pulley off and put a new one on. The power steering and A/C belt is tensioned by a tensioner pulley. Mine went bad and was ...

Ad

adjusting bolt. This loosens the tension to slide the belts on and off. Once the new belt is on, apply pressure to get the belt tight (a long flathead screwdriver or crowbar should do) and while tight

can you change just the bearing on a belt tensioner on a 2002 neon hi from uk these tensioners new come as a complete unit and would not advise trying to replace bearing and use the old mount/adjuster

I just need to know where the alternator is located on a 2004 dodge neon 2.0L SXT Fig. View of the alternator after removing the splash shield - 2.0L engines Removal & Install - 2.0L Engines ...

replace tensoioner belt adjuster Remove the belt first. Then loosen the upper motor mount & jack the engine from the bottom using a wooden block & jack. This will give you enough room to get ...

...adjusting nut. 22. Connect the negative battery cable. Adjust the alternator belt. Thanks!! just above the right side drive axle on the motor. its not easy to see The alternator is always under the ...

need to replace alternator belt on 2000 dodge neon, but need pulley diagram The 2000 neon the belt goes from teh alternator to the Harmonic Balance pulley only. The adjuster is on the alternator and ...

Question about 1996 Neon

1 Answer

serpiten belt is lose how do I tighten my servinen belt in a 1996 dodge neon Have to loosen pivot bolt at bottom of power steering, plus top adjustment and use 1/2" drive bar in hole supplied in ...

Question about 2005 Neon

1 Answer

alternator belt tension? how do I properly set the tension on the belt alt belt has a slip torque adjuster. belt should be set to 1/4 to 1/2 inch deflecting pushing on the belt between the longest ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2002 Dodge Neon
2002 Dodge Neon

861 Questions

2004 Dodge Neon
2004 Dodge Neon

762 Questions

2003 Dodge Neon
2003 Dodge Neon

743 Questions

2005 Dodge Neon
2005 Dodge Neon

710 Questions

2000 Dodge Neon
2000 Dodge Neon

606 Questions

Manuals & User Guides

Loading...