Questions & Answers for: Homelite how do i adjust the mixture

adjust. It sounds like the carburetor is not pumping fuel. There are a few suggestions; mix up some fresh gas today(bad gas); the carburetor may need some adjusting, or the cylinder compression may be

...then rev up the throttle and adjust the high side which is towards the filter turn the mixture screw in till it revs to the highest point which I call the sweet spot your pretty close to what you ...

...adjust mixture homelites fuel mixture is 32:1 and you can try to adjust the jets or jet on the carb if it has two jets turn them all the way in to the right but dont over do it just till they stop ...

Need to know which adjustments on carb are for what results. Generally there are 3 adjustments depending on the model. An idle speed screw that controls the idle rpm of the saw, the idle mixture screw

...mixture screw, just adjust at idle rpm. You will also adjust the low idle mixture screw to give you a smooth transition from idle to throttle up. Once this is obtained, you adjust the third or idle ...

adjust the low or idle mixture screw. Start by turning the low (idle) mixture out (counterclockwise) by 1/8 turn at a time and wait a few seconds to see what happens. Try that a few times but remember

...mixture for the UT21566 Homelite trimmer Hi dcheddy... Before you remove or try to adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle ...

...adjust the fuel/air mixture, start the saw and turn the adjustment screws in or out a little at a time until you get the saw running properly. There is no "set" adjustment... as the saw motor ages, ...

...how do I adjust the carb Start with 1 turn out from bottom on both and adjust from there as needed. The screw closest the engine is low speed mixture adjustment and the outer is high speed mix. ...

what are the ajustment for h omelite 26c blower low and high speed mixture adjustments idle speed adjustments fuel mix adjustments