Questions & Answers for: Harley Davidson FLHR - FLHRCI Road king add oil

add oil? The oil light is supposed to turn on before you start the engine because since the engine is not running, there is no oil pressure. That is what this light is telling you, no oil pressure. To

...add oil there where the little oil stick is? This isn't my transmission right? It sounds like you have located the fill/check port for your transmission. On the little dip stick, the oil level should ...

oil listed. One is a "WET" quantity that you add when you simply drain the tubes and refill them. The other is a "DRY" quantity that you put in whenever you disassemble the tubes. I usually use 30 wt.

...the lower line is the "FULL COLD" line. As long as the oil level is between the two lines, do not add oil. Resist the temptation to "top off the oil tank". Do not overfill the oil tank. Good Luck ...

...oil level half way between the add and full mark when hot. 2. Run oil breather lines from head into a TEE fitting below carb/induction module then a single line into a mini filter under frame. 3. ...

...the oil fill opening to the "add" and "fill" marks) is: For bike on jiffy stand - 5  3/16" to full and 6  1/16 " to add. For vehicle upright - 4  15/16" to full and 6  3/8" to

oil level in tank and it is between the add and full mark. With engine at normal operating temperature 180-230 degrees and the use of a 10 micron synthetic media oil filter, oil pressure will be 30-38