Questions & Answers for: Jeep Cherokee add oil

...oil and add some additive to it. If it still knocks, it's probably your bearing. Pull engine, replace crankshaft and rod/main bearings. You have not said where the knocking noise was coming from, If ...

oil change, do it and add a good lubricating solvent such as Marvel oil, which will gently clean relief valve in pump and passageways. High oil pressure is actually a good thing but excessive pressure

...add fluid as needed. [2] Fill no higher than 1/2" below fill plug opening. TORQUES Oil Drain Plug.....30 ft-lbs Transfer case Alum Case Fill Plug.....18 ft-lbs Drain Plug.....18 ft-lbs Transfer case ...

...add Oil? Really you should not have to add oil. But to find out have jeep on level surface and use the dip stick to check. Check with car off, pull dip stick out and wipe off and reinsert, Pull back ...

...to fill the filter before you put it on...doesn't need to be "full full" but just pour some in it, tap it on the ground a few times and add more...helps priming after oil change. 5qts castrol ...

...the engine still running.If it needs oil,you add it down the tube that the tranny dipstick goes.Tranny oil bottles often come with a tube made into the lid to make things a bit easier.Hope this ...

...add oil, brake, antifreeze, etc... But don't know how to change transmission. Help! this is not a serviceable item and must be taken to the dealer who has the specialist equipment to perform this ...

...add oil after the old oil is drained. I would drive a different vehicle to the store and get 5 quarts of oil. And add one quart at a time until it is full again. Depending on how long you ran the ...

where do add the 6 oz of compressor oil? The same place the freon goes in...just get the charged can of oil freon mixed....

add your oil at a cap on the valve cover warm up the car and have someone remove the cap and look inside with a light as you rev up the engine. they should see oil splashing around. If not shut it off