...wont be easy.) well that is pretty much all u have to do to remove the trans axle. i would just sugest replacing the entire trans axle and not just the outer cv joint becuase it will be easier in the ...
...accord. i tried n tried but it wont brake loose If you are referring to the axle nut on the end of the axle shaft, you may need an impact wrench, or make sure to bend the nut back (straighten out the ...
axle and wont be able to put the bolt back on to the axle. You have to remove the axle from the main hub first before you be able to slide the axle out from the transmission. do not remove or undo any
...Took brake caliper off, and retaining nuts off of wheel lugs. disconnected emergency brake cable. Rotor will move in and out 1/8" but wont come off, what gives?? it is probably rusted to the axle ...
accord weth a 2.2 sohc auto trans. I replaced the cv axle and replaced the throttle body weth one off a prelude weth the same motor. It ran for a few but then i turned it off and now it wont start. It
...wont slip off the jack if you dont have axle stands you will need to get some as its not safe working under the car without it being on stands plz rate this solution as i have a whole page of unrated ...
Question about 1996 Accord
...accord lx problems getting left side axle into intermediate shaft axle wont set into intermediate shaft at all I haven't tackled this yet on my 97, but on my previous Honda, the axle was painted on ...
Question about 1993 Accord
...accord goes into gear but when i pull the clutch out and give it gas it wont move I just had the clutch replaced you pulled the transaxle and replace the clutch disc, pressure plate and throwout ...
Question about 1992 Accord
My car is running fine but when I put it in gear it won't move, Do you know what could cause this? manual or automatic ? clutch gone if manual , torque converter maybe If it is an automatic ...
Question about 1992 Accord
...wont go 98 honda accord Since you say the clutch pedal has good pressure then the hydraulic release system should be working properly. It still would be a good idea to have someone press on the pedal ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions