...AC but I do not know which. I hooked up my multimeter to the connector of both fans and I am getting 0 volts on the driver side and .005 on the passenger. All fuses are good, any ideas? check the fan ...
...AC but I do not know which. I hooked up my multimeter to the connector of both fans and I am getting 0 volts on the driver side and .005 on the passenger. All fuses are good, any ideas? Also my dash ...
...the air condition was checking and it's ok, Could be a sensor problem? Does the car have the check engine light on? Verify the air control valve for proper operation, it only works when the ac is
...the leads to the two pins in the connector of the crank sensor.Then have a helper crank engine over.You should see ac voltage,if not,then your crank sensor is bad. how to testing ...
sensor still won't start just turning over Back to basics. You need spark, fuel, and compression (manifold vacuum). Before you replace any more parts, check to make sure that you have no stored codes.
...AC to check the fan. If the fan now works then you have a bad relay which needs to be replaced. Don't forget to return the "borrowed" relay to its position in the fuse box. Finally, there is an ...
...told it might simply be a freon thing...or that it's a diagnostic thing relating to the AC. If that's all it is. I'm not too concerned about it. 2. I put a new battery a ...
...ac,rear wiper,4lights total,cam sensor wires old breaking off at connecter, You 1st need to determine if you have a fuel problem or an electrical problem. 1st pull one of your spark plug wires and ...
Usually answered in minutes!
602 Questions
526 Questions
373 Questions
335 Questions
133 Questions