Questions & Answers for: Ford Explorer abs sensor

...ABS sensor may be the problem but would I need to replace both sides or is there just one? Napa guy said he couldn't find a rear ABS sensor for a 04 explorer is it called something else? There is a ...

...ABS sensor on this assembly. Just removed the old pads and hardware and installed new ones. Thanks for any help! if this has rear abs,the sensor on the rear axle housing might be bad.low brake fluid ...

...abs sensor on the 2005 ford explorer? hi, It is not expensive to replace the ABS sensor in your car. It costs exactly $26.65. I have provided the picture and the link in which you can buy the product ...

...abs sensor does not turn off after disconnecting the battery, then there is a real problem, a faulty sensor or ABS malfunctioning. When the ABS led comes on immediately after you start the car and ...

...abs speed sensor it is on the side of the transmission case near the rear This is for a 4X4 only,for the rear it should be on the rear end housing on top, for the two front one's, the speed sensor is ...

...showing " check avtrak and the abs light is on, is this a major issue or could it be the sensor from the abs system? Could be an ABS Wheel Speed Sensor Need to Have it checked out ...

ABS sensor, then there is the ABS brain, and sometimes a differential speed sensor. You would have to pull off and clean the wheel sensors at all 4 wheels just to eliminate debris blocking the sensors

...ABS wheel speed sensor ring. Installation Install the new ABS wheel speed sensor and the Wheel Speed Sensor Ring Installers on the halfshaft as shown. Using the Wheel Speed Sensor Ring Installers, ...

...ABS light on the dashboard stays lit check all the sensor units and wires at the wheels . The track stabilisation also use the sensors and wires . Run fault codes and check for abs and other faulty ...

...ABS sensor is having electrical connection issues, or a rotor came out warped from the factory, if nothing was wrong with the ABS beforehand. I'd take apart the calipers and rotors again, make sure ...