Questions & Answers for: Chevrolet Blazer abs sensor

...abs light will come on for a number of things. The sensor is ajar. The sensor failed or they aren't wired. secondly the whole ABS unit might be bad. Getting the ABS mo dual is very expensive and to ...

...sensor gives a different output from the other 3 wheels which the abs computer thinks is wheel slip and the abs is activated. This may only apply to the front sensors, your vehicle will likely just ...

will always stay on even if you pull abs main fuse ,usually its awheel sensor on frt hubs ,broken wire around upper control arm,you can visually inspect,i will not recomend pulling abs light from dash

...abs sending unit(module/sensor). this sensor/module seems to be malfunctioning and it will need to be replaced. there may just be a lose connector but, most of the time, the abs light will come on if ...

...ABS TO ACTIVATE. CHECK THE WIRES FROM THE SENSORS FOR BREAKS OR CHAFFING. AN OHM READING OF THE SENSOR SHOULD BE 850-1200 OHMS, AND AND A-C VOLTAGE READING SHOULD BE 100 MV WITH YOU TURNING THE WHEEL ...

...ABS sensor, you can try to clean the ABS sensor with brake parts cleaner and inspect the wire leads. The ABS sensor are common to get dirt and the wire leads my be damaged due to corrosion or a break ...

ABS sensor look like on a 97 chevy blazer mid size blazer- take off wheel-brake caliper-brake caliper bracket- rotor-and behind the hub u will see a wire going into the back of hub and is secured by a

...ABS sensor that controls many things like ABS and Traction control on alot of cars. Check to make sure the sensor is plugged in properly and not cracked. Clean gear on spindle that abs sensor is real ...

...ABS kicks in then the sensor is bad. I spent $3800 trying to get my abs brakes fixed ,in all Garber Chevey dealer mechanic said the problem was in the transmission sensors .In short I still dont know ...

...and they are telling me that the abs sensor is bad and isnt worth fixing, If the abs sensor is bad would the brake warning light come on as well probally not have wheel bearing checked....hope it ...