Questions & Answers for: Dodge abs sensor

...abs sensor: Had this problem with my 1999 Ram 1500. There is a sensor at the top of the rear differential for the ABS system. That sensor went bad and replacing it took care of the problem. What ...

Ad

abs sensor located on my 99 dodge 1500 4x4? my abs light and brake light are on and i may need to replace my abs sensor but don't know how to find it... Normally your ABS sensors are on the wheel hubs

Ad

ABS IS OK - IS THIS JUST A SENSOR? I had this problem. When they test the ABS with the car not running the ABS was OK. When the take the car for a drive still hook up to the tester, they find that one

Question about 2006 Caravan

1 Answer

...abs module over top of transmission..if you have communication..you may have a speed sensor fault..if a front sensor,check wiring behind splash shields in fenderwells,if rear sensor fault,most likely ...

...abs if a sensor is bad You might need to have brake system bled. If that's not the case I would check both front wheel hubs (bearings) for excessive play. Too much play will cause your problem. Your ...

i have a ram 2500 and the abs pump will not stop running...what could be the problem? It can either be wheel sensors abs sensors or the abs pump itself. You are going to have to diagnose the problem ...

Question about 2001 Ram 2500 Truck

1 Answer

...sensor in the rear diff. These are all direct inputs to the ABS module which are then calculated and sent out on the "bus" communication wire which is read by the cluster. It would be much easier to ...

Question about 2001 Ram 2500 Truck

1 Answer

...abs sensor and broken abs sensor harness wires. You can visually instect the harnesses to see if any are broke. You can use a DVOM to check the sensors. The quickest way to identify the problem is ...

...ABS sensor on one of the wheels is bad. There are four sensor on your vehicle one for each wheel. Also the ABS as a computer which uses the sensor to brake/open wheels in a slide, braking to keep the ...

...abs sensor checked. The sensor may have been broken during repair. Also check the tip of the sensor for metal fragments. the sensor is a magnent and if it is covered with metal from the rotor or pads ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Dodge Caravan
2000 Dodge Caravan

2,271 Questions

1999 Dodge Durango
1999 Dodge Durango

2,049 Questions

1999 Dodge Ram
1999 Dodge Ram

1,788 Questions

2000 Dodge Durango
2000 Dodge Durango

1,616 Questions

2005 Dodge Caravan
2005 Dodge Caravan

1,496 Questions

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...