Questions & Answers for: Toyota Land Cruiser 98 degrees

Ad

replaced motor in 98 parodo quad cam v6 need to no were pipes go does any one no were i can get a diagram for a parado 98 model . or maybe you might no were these bits go. theres a round thing on the ...

Ad

I just replace my prado ignition distributor and it hardly start I just replace my prado ignition distributor and my prado does'nt crank start easily it btake two to three time then it start what the ...

Ad

wheel alingment specs for toyota land cruiser what are the specs for wheel alignment on toyota landcruiser hzj75 Camber Left−right error 1°00? ± 45' Caster Left−right error 3°00? ± 1° ...

Need wheel alignment specs for Toyota Land Cruiser 200. Please help !! Well your Caster should be +2.0degrees to +4.0degrees Your Camber should be at .+2 degrees to +1.7 degrees but I would keep it ...

what type of fluid do i use to top up a 98 hz1 Just wondering what type of fluid do i use to top up a 98 hz1 cruiser power steering? Respect, Steve You can use normal ATF (automatic transmission fluid

I need to know how to get the starter motor of a 98 prado I need to know how to get the starter motor of a 98 petrol prado, out of the engine bay. I have already got it disconnected as well as the ...

Question about 1998 Land Cruiser

1 Answer

hi.i need the torque settings for the cylinder head on a toyota prado 3.0td.thanks 12-point bolt head step 1. 33 ft lbs. step 2. additinol 90 degrees. step 3. additinol 90 degrees. 6-point bolt head. ...

Question about 1998 Land Cruiser

1 Answer

torque settings on cranck sharf bearings Torque settings for V-6 engine. Main bearing cap bolts torque: Torque: 27 N·m (275 kgf·cm, 20 ft·lbf) Mark the front of the main bearing cap bolt with ...

Hi I need the torque settings for both the cylinder head and the bottom end bearings for a 1997 Toyota Prado (3.4litre petrol). Thanks 1997 Toyota Prado 5VZ-FE Cylinder head bolts: Tighten the ...

...1995-98 Engine code: 1FZ-FE, 1HD. Stage 1: 20 Nm (Start tightening bolts from center to outwards) Stage 2: 39 Nm Stage 3: Rotate each bolt by 90 Degrees. Stage 4: Further rotate each bolt by 90 ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...